FIBERKOTE PENETRATING SEALER FPS-820

APPLICATION PROCEDURES

Surface Preparation

• Check the whole surface that will be coated, seal the screw heads using appropriate cements. Allow to dry, scrub well and wipe out all dusts.
• Moisture content of substrate must be ? 16% measured by Protimeter and alkalinity (pH) of substrate must be 7 – 8 measured by universal pH indicator.
• Sanding lightly along the grain with sandpaper no. 240 and clean well (optional).
• Surface must be dry, clean, free from dirt, dust, mold, oil and all contaminants. Clean any area affected by mold, moss and fungus with FUNGICIDAL WASH.

Primer coat :

• FIBERKOTE Penetrating Sealer FPS-820 (Solvent Based). Apply 1 coat by brush, without thinning. Material consumption : ± 200 ml / m?2; (± 5 m?2; / liter).
• Allow to dry, minimum 2 hours (depends on temperature and

Top coat :

• FIBERKOTE FBK-888 / FBK-889, thinning with 10% - 20% clean water according to application need. Apply 2 - 3 coats by brush, with recoating interval minimum 2 hours (depends on temperature and humidity).

For applications on the floor / deck :

• Apply FIBERKOTE FBK-888, follow the application procedure above. After fully dry at least 24 hours (depends on temperature and humidity), apply PROPAN USE-60 CLEAR GLOSS, 2 coats by brush / spray, with recoating interval minimum 4 hours.
• Leave to completely dry for three to five days before usage.