Cerakote CTC-997 PU HQ
Cerakote CTC-997 PU HQ
CERAKOTE CTC-997 PU HQ is a paint from the CERAKOTE product series which is specifically designed to recondition old/dirty bathtubs to make them new again.
Superiority :
- Top quality 2K polyurethane paint
- Thick film coating with very attractive appearance
- No yellowing
- Easy to spread, can be brushed
- Easy to apply
Packaging available: 1 liter-set
Application procedure
- Clean the bathtub to be painted from dirt, mildew, etc. until it is completely clean, then sand it using sandpaper no: # 240 – 400, depending on the dirt that is attached. Painting on metal bathtubs must be clean of rust first then coat using anti-rust epoxy paint (zinc chromate/zinc phosphate)
- Mix a set of primer coat paint (CERAKOTE CTP – 980 WB) with a weight ratio of comp. A : comp. B = 4 : 1. For applications using a spray gun, it can be diluted with epoxy thinner or PU thinner around 5 – 10%.
- Spray the paint mixture using an epoxy roller/brush, just one coat until evenly distributed.
- If the condition of the substrate (bathtub) of the old paint is not peeling off (it’s just dull), then you can immediately paint the top coat CERAKOTE CTC-997 PU HQ.
- After the base paint CTP-980 WB has dried at least overnight (1 2 hours), you can immediately do the top coat painting by first sanding it using fine sandpaper no. #400, with the aim of removing dirt / dust attached to the base paint when the paint is not dry. Then clean the dust from the sandpaper.
- Mix a set of CERAKOTE CTC-997 PU HQ with a volume ratio of comp. A : comp. B = 2 : 1, dilute using PU thinner about 10 – 20%, stir until evenly distributed.
- Then spray onto the substrate (bathtub), for better results use an HVLP (High Volume Low Pressure) spray gun. For Top Coat, it can be done with just one layer by spraying it evenly and rather thickly. Spreadability of about 3 – 4 m2;/l-set
Play Video