Decor Alkali Resisting Primer 310
Decor Alkali Resisting Primer AS – 310 is a solvent based alkali resistant primer for walls. This product is suitable for painting new walls such as concrete walls, cement plaster, asbestos cement and GRC panels. Very effective at preventing damage to paint by the very high alkaline level of the cement. DECOR ALKALI RESISTING PRIMER AS – 310 has good penetration and adhesion properties, thus providing perfect results for the final coat of paint.
Superiority :
- Prevent damage to the finish paint by the very high alkali cement of the walls
- Very good adhesion
As a good base for the next layer - Very good covering power
- Easy to apply
Packaging: 2.5 Liters & 20 Liters
NEW PAINTING
1. Surface Preparation
- All wall surfaces with defects such as hairline cracks or small holes, repaired using PROCRETE Cement Filler CF – 700 mixed with PROCRETE Bonding Agent BDA – 810 and water, then let it dry for at least 5 (five) days.
- Make sure the water content / humidity of the wall? 16% is measured using a Protimeter tool and the wall alkali content (pH) 7 – 8 is measured using a Universal pH indicator tool.
- The wall surface must be cleaned of dirt, dust, grease, oil, remaining cement water and others .
2. Base Coat
- Apply 1 (one) coat of base coat DECOR Alkali Resisting Primer AS – 310 (Solvent Based) without dilution using a roll for wall surfaces with an alkaline level very high. Let this layer of base paint dry for at least 2 (two) hours.
3. Final Coat
- Apply the final coat according to the needs of the exterior or interior.
REPAINTING (OLD PAINT HAS BEEN BROKEN & PEELED)
1. Surface Preparation
Check the condition of the old paint that is still attached to the wall, if the old paint is damaged or calcified or peeling, then do the following steps
- Peel off all the old paint using PROPAN Paint Remover PPR – 735 (blue can) until it reaches the wall plaster, then clean it and let it dry.
- All damaged wall surfaces are repaired using PROCRETE Cement Filler CF – 700 mixed with with PROCRETE Bonding Agent BDA – 810 and water, then let it dry completely for at least 5 (five) days.
- Make sure the moisture content / humidity of the wall? 16% is measured using a Protimeter tool and the wall alkali content (pH) 7 – 8 is measured using a Universal pH indicator tool.
- The wall surface must be cleaned of dirt, dust, grease, oil, remaining cement water and others .
2. Base Coat
- Apply 1 (one) coat of base coat DECOR Alkali Resisting Primer AS – 310 (Solvent Based) without dilution using a roll for wall surfaces with an alkaline level very high. Allow this base coat to dry for at least 2 (two) hours.
3. Final Coat
- Apply the final paint according to the needs of the exterior or interior.